- CISCO ASA 5510 SETUP GUIDE HOW TO
- CISCO ASA 5510 SETUP GUIDE SERIES
If you specify the ip_address, then you set the inside or management interface IP address, depending on your model, instead of using the default IP address of 192.168.1.1. To restore the factory default configuration, enter the following command: hostname(config)# configure factory-default ]
PIX 515/515E Default Configuration Restoring the Factory Default Configuration. ASA 5510 and Higher Default Configuration. Restoring the Factory Default Configuration. This section includes the following topics: See the "Setting Transparent or Routed Firewall Mode" section for more information about routed and transparent firewall mode. See Chapter 3, "Enabling Multiple Context Mode," for more information about multiple context mode. The factory default configuration is available only for routed firewall mode and single context mode. The factory default configuration is supported on all models except for the PIX 525 and PIX 535 security appliances.įor the PIX 515/515E and the ASA 5510 and higher security appliances, the factory default configuration configures an interface for management so you can connect to it using ASDM, with which you can then complete your configuration.įor the ASA 5505 adaptive security appliance, the factory default configuration configures interfaces and NAT so that the security appliance is ready to use in your network immediately. The factory default configuration is the configuration applied by Cisco to new security appliances. To determine the features that are supported for your model before you start your configuration, see the "Supported Platforms and Feature Licenses" section on page A-1 for a detailed list of the features supported for each model. This guide might not list each supported model when discussing a feature. 
For example, the ASA 5505 adaptive security appliance does not support security contexts. Some models do not support all features covered in this guide. For these hardware-based differences, the platforms or models supported are noted directly in each section. Moreover, the ASA 5505 includes a built-in switch, and requires some special configuration. There are some hardware differences between the PIX and the ASA security appliance.
CISCO ASA 5510 SETUP GUIDE SERIES
This guide applies to multiple security appliance platforms and models: the PIX 500 series security appliances and the ASA 5500 series adaptive security appliances.
Working with the Configuration Getting Started with Your Platform Model. Setting Transparent or Routed Firewall Mode. Getting Started with Your Platform Model. This chapter includes the following sections: CISCO ASA 5510 SETUP GUIDE HOW TO
This chapter describes how to access the command-line interface, configure the firewall mode, and work with the configuration.
Configuring an External Server for Security Appliance User Authorization. Managing Software, Licenses, and Configurations. Configuring Tunnel Groups, Group Policies, and Users. Configuring ARP Inspection and Bridging Parameters. Applying Application Layer Protocol Inspection. Configuring AAA Servers and the Local Database. Configuring DHCP, DDNS, and WCCP Services. Configuring Ethernet Settings and Subinterfaces. Configuring Interfaces for the Cisco ASA 5505 Adaptive Security Appliance. Getting Started and General Information.
0 kommentar(er)
